Anybody got any ideas

[Compenstine]

First impression is that it looks cool... Second impression may be a real pain getting the coils onto the posts. I do like the way you have holes on both sides of the coil. That would create good juice flow to the coils. 

[FXRich]

One reason I'm going to raise the posts, make it easier to get the coils in. I will have to make the cap taller but that can't be helped. I'll redraw and repost take me a few days maybe but got to make everything fit. I might design a single coil setup too. I'm kind of copying kanger but I'm screwing the cap on instead of pressing it in.

[Bebop]

One of the things that concerns me is the screw on cap vs the o-ring fit. The transfer of heat has to be way higher with a screw on cap. And if the heat transfer is uneven you may have a heck of a time getting it off.....

[FXRich]

I was planning on putting a Teflon O-ring in the screw on cap, but I haven't gotten that far yet.

 

 

I raised the coils and made the posts smaller, and went with 4-40 set screws.