brian1g Posted March 24, 2010 Share Posted March 24, 2010 Just a quick question, I have noticed when I'm using an atty on the vp pt and pull it off, put it on the Ego I get horrible vapor production. Should I be keeping these attys separate? I have been using all of my attys on both units and I'm starting to have problems with all of them lol. Link to comment Share on other sites More sharing options...
Mark Posted March 24, 2010 Share Posted March 24, 2010 Hey Brian, I have had the same problem. You're probably screwing the attys down too tight. If you take the atty off and look at it from the bottom, you'll see a little hole in the center--if you carefully pull on the center of that (with a paper clip or something similar) you can pull it out enough to make contact. Hope this helps. Link to comment Share on other sites More sharing options...
brian1g Posted March 24, 2010 Author Share Posted March 24, 2010 Cool, I'll give it a shot. Thanks so much for your help Mark. Link to comment Share on other sites More sharing options...
Christopher Posted March 24, 2010 Share Posted March 24, 2010 I think marks right that should help a little but it's probably more the comparison. Imagine driving say a Ford Focus and getting into a Lambo then going back to the focus, you'd probably think the focus was even slower after driving a Lambo around all day. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now