Eaglewtchr Posted June 3, 2014 Share Posted June 3, 2014 A friend gave me a dripper and i can't really find any info about it. On the side of it it says, Smok Dripper RDA. My friend has it built already and my ohm meter says .51 but im not sure its setup right. Here's a couple pics.. Any info or advise? Link to comment Share on other sites More sharing options...
Tony8806 Posted June 3, 2014 Share Posted June 3, 2014 Is that a coil wrapped around the post?! You could change it to a nano coil which is just a smaller coil, IF its not producing enough vapor or vaporizing the smoke in less than 2 seconds. There's some pretty smart veteren vapors on here they should give you a better idea on your "problem". Link to comment Share on other sites More sharing options...
Eaglewtchr Posted June 3, 2014 Author Share Posted June 3, 2014 No, The coil leads go thru the posts. The wick is wrapped around the posts. Link to comment Share on other sites More sharing options...
Compenstine Posted June 3, 2014 Share Posted June 3, 2014 What battery are you using? Link to comment Share on other sites More sharing options...
Eaglewtchr Posted June 3, 2014 Author Share Posted June 3, 2014 (edited) VTC4 in a Nemesis clone. He already set it up and i checked it. It just has a clogged draw to to and not much vapor. I found "1" video review for it and the guy had the coil on the other side but used ecowool. I have some 1.8ish ecowool pre-made. Just not sure they will fit right. Might try those and see. Edited June 3, 2014 by Eaglewtchr Link to comment Share on other sites More sharing options...
Joshuab3687 Posted June 3, 2014 Share Posted June 3, 2014 Can you take a pic of the airhole? You may need to drill it a tad larger for increased flow Link to comment Share on other sites More sharing options...
Tony8806 Posted June 3, 2014 Share Posted June 3, 2014 Stick to cotton. May need to open your airholes^ Link to comment Share on other sites More sharing options...
Eaglewtchr Posted June 3, 2014 Author Share Posted June 3, 2014 It only has 1 air hole 2mm.. Link to comment Share on other sites More sharing options...
Eaglewtchr Posted June 3, 2014 Author Share Posted June 3, 2014 I'm just trying to figure out how to set it up. Should I use more cotton than I would on an RBA/RTA like the KFL+ Since it doesn't have a well to hold more juice? Does it matter which side the coil goes on? Can i run dual coil? I'm thinking i can't because it only has 1 air hole.Thanks. Link to comment Share on other sites More sharing options...
mvince201 Posted June 3, 2014 Share Posted June 3, 2014 1 air hole = 1 coil. The air hole must always be placed directly in front of the coil. Joshuab3687 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now