Inception Coil

[Joshuab3687]

I would like to try in a KPT or Nautilus head. I think it would be a good build for them.

The leads would def be pointed in the right direction! But what about the coil size? Would that fit in a PT head?

[Compenstine]

The leads would def be pointed in the right direction! But what about the coil size? Would that fit in a PT head?

I would have to work on getting it the right size. I would have to do the inner as a micro coil for sure. I think the harder part would be wicking it. I would more than likely have to use a very small piece of silicon wick or as I do the outer coil I would have to wick it as I wrap it.

[Joshuab3687]

I'd wrap the center as a super nano and outer as a micro. Might give more room for wicking

Edited March 27, 2014 by Joshuab3687

[iheartvape]

That would be sick in a kpt or nautilus head!

[Compenstine]

With the KPT you need to wick the center of the coil or it will leak.and give dry hits. I tried that once already with just a standard coil setup. It would be near impossible to wick the inside of a super nano.

[Joshuab3687]

If you do it just right, you may be able to get a little on the bottom and around the outside edge of it.

[Vispera]

If you do it just right, you may be able to get a little on the bottom and around the outside edge of it.

Wish I would have took a pick of my kpt chimney coil I just filled the outer part of the coil for mine worked great I think if I could get the inception coil right might try that