Jump to content

Breaktru

VT Member
  • Posts

    82
  • Joined

  • Last visited

Posts posted by Breaktru

  1. Some ejuice tend to gung up coils more than others. I find some getting crusted with burnt on juice. Scraping the crust with an extacto knife helps and followed with a PGA rinse then dry burn for a sec or two.

    It's nice to have more than one on hand to dedicate to a particular flavor juice. Washing between differnt type of ejuice is sometimes not successful in removing the previous eJuice flavor.

  2. How about Grandmas custard with a slight cinnamon hint on exhale...

    I mix this @ 36 mg nic/100% pg base, with a target of 12mg nic, 70pg/30vg

    Vanilla Custard 15%

    Bavarian Cream 3.5%

    eggnog 2%

    graham cracker 1.5%

    butter 1.75%

    sweetener (by HDV 5%sucralose) 5%

    + 2 drops french vanilla

    This gets better with a hot water steep, and a minimum of three days.. Although its hard to leave alone the next day!

    Sounds delicious Krystal. Got to try it

  3. The DNA20 has Mode Selections as follows:

    * 5 clicks of the Fire button enters Locked Mode and 5 clicks to unlock.
    With the module in Locked Mode:
    * Holding the UP and Fire buttons simultaneously for several seconds and you access the Left Mode. Continue holding the buttons and you access Right Mode. This Flips the Screen 180 degrees.
    * Holding the Down and Fire buttons simultaneously for several seconds accesses the Stealth Mode and Normal Mode. Stealth mode allows you to vape without the screen illuminated.

    When idle, the board goes into Power saver mode after a few seconds where the screen dims to half bright and then a few seconds more extinguishes.

  4. The Wattage value is easy to read.

    Getting ready for the build.............

    dna20_build01.jpg

    dna20_build02.jpg



    I coiled a length of 28 gauge Kanthal A1 wire and clipped my output on to various points to achieve the resistance in the test.

    Testing at 7 watts:
    1.5 ohm - 3.6v
    1.7 ohm - 3.5v
    2.0 ohm - 3.7v
    2.5 ohm - 4.2v
    3.1 ohm - 4.6v
    3.5 ohm - 4.9v
    5.1 ohm - 6.0v
    6.4 ohm - 6.7v

    Testing at 20 watts:
    1.5 ohm - 5.6v
    1.9 ohm - 6.3v
    2.3 ohm - 6.9v
    2.5 ohm - 7.0v
    2.7 ohm - 7.3v
    3.0 ohm - 7.8v
    3.5 ohm - 8.3v - This is the highest resistance that doesn't warn: "Check Atomizer"
    3.6 ohm - "Check Atomizer"

×
×
  • Create New...

Important Information

Terms of Use Privacy Policy Guidelines