I purchased a Raptor breakout board and a 120W raptor (20Amp) , later on decided to go with a 200W raptor (40Amp)
The brakout board is already populated with:
2 22uF SMD capacitors
1 5.6v SMD Zener diode
1 220ohm thin-film SMD resistor
1 4.7kohm thin-film SMD resistor
1 SMD pFET/P-channel MOSFET
With the kit comes 2 9Amp re settable fuses, now from what I understand I need 2 more 9Amp re settable fuses and the board should work with 200W raptor, Am I correct??? if not what do I need ?
I understand that it needs to be bridged because the through holes will not align.
your help is highly appreciated.
P.S. attached pictures of the breakout board and raptors in question.
Raptor Breakout board
in Modders Forum
Posted · Edited by HZangana1980
Hi Everyone
I purchased a Raptor breakout board and a 120W raptor (20Amp) , later on decided to go with a 200W raptor (40Amp)
The brakout board is already populated with:
2 22uF SMD capacitors
1 5.6v SMD Zener diode
1 220ohm thin-film SMD resistor
1 4.7kohm thin-film SMD resistor
1 SMD pFET/P-channel MOSFET
With the kit comes 2 9Amp re settable fuses, now from what I understand I need 2 more 9Amp re settable fuses and the board should work with 200W raptor, Am I correct??? if not what do I need ?
I understand that it needs to be bridged because the through holes will not align.
your help is highly appreciated.
P.S. attached pictures of the breakout board and raptors in question.