Jump to content

HZangana1980

Recommended Posts

Hi Everyone 

I purchased a Raptor breakout board and a 120W raptor (20Amp) , later on decided to go with a 200W raptor (40Amp)

The brakout board is already populated with:

2 22uF SMD capacitors 

1 5.6v SMD Zener diode 

1 220ohm thin-film SMD resistor 

1 4.7kohm thin-film SMD resistor 

1 SMD pFET/P-channel MOSFET

With the kit comes 2 9Amp re settable fuses, now from what I understand I need 2 more 9Amp re settable fuses and the board should work with 200W raptor, Am I correct??? if not what do I need ?

I understand that it needs to be bridged because the through holes will not align. 

your help is highly appreciated.

P.S. attached pictures of the breakout board and raptors in question.  

262970921180-7.jpg

images.jpg

1__05128.1479699918.300.200.jpg

Edited by HZangana1980
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

Terms of Use Privacy Policy Guidelines