Jump to content

VT200 with Kanger SubTank showing "Shorted" on display


Recommended Posts

So this is a new thing on the display for me. I've had this setup for over 6 months now.  Yesterday I changed the coil and put in a new factory built Kanger OCC 0.2 ohm coil. After prepping the coil and putting everything back together and letting it sit for a few minutes I went to fire it and the display read "shorted." I'm guessing it's the coil, but not entirely sure. Any thoughts? Thanks.

20160519_193029_zpspmkmgm2u.jpg

Link to comment
Share on other sites

Do you have it in wattage or tc mode? Not sure of the specifics on that device, but it may not recognise a .2 coil in wattage mode. The .2 kanger coils are ni200, and should only be used in TC mode.

Or it could be a bad coil, it happens from time to time.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

Terms of Use Privacy Policy Guidelines