Evolv DNA30 board showing 0.00 ohms

[Monkeyman]

My Evolv DNA30 board was new about 2 months ago (replaced @ 3 months under warranty). About a month ago, I started having an intermittent issue with the ohms symbol not displaying although the correct resistance would display. Rebuilt my Kayfun tonight and now it's reading 0.00 ohms. I wrapped my coil at about 1.3 ohms so I know it's not too low.

Has anybody else had an issue with the DNA30 chips? The mod manufacturer warranty is 4 months so this is now out of warranty. I don't feel like paying $80 (plus shipping) for them to replace the board (again).

Any suggestions?

[Compenstine]

pull the battery if you can. let it sit for min and then put the battery back in. That will reset it. It may be that you have a short in your coil. if you have a factory coil tank, try it and see if it reads the same as the kayfun.

[Earthling789]

Check your MOD's top-pin too... Floating pins can be pushed too far down, and sometimes spring-loaded pins can stick and not make contact.with the atty.

[Tam]

Just a thought, what are you using to measure the coil's resistance? Have you tried something else to make sure your first measurement was correct?

[spydre]

^^

What Tam said. Don't depend on your mod to read the resistance from your coil - could be a problem with the coil, not with the DNA 30 board. You have a separate tester?