Jump to content

FXRich

VIP Member
  • Posts

    1,759
  • Joined

  • Last visited

  • Days Won

    66

Reputation Activity

  1. Like
    FXRich got a reaction from cany in Kanger subtank mini   
    I still use the old reliable subtank minis, I use rebuilt coils but still good flavor. Some of my subtank minis are over 10 years old but still going strong.
  2. Like
    FXRich got a reaction from Tam in DIY help please   
    60% 100mg/ml + 40% pg = 60%mg/ml. to make 100 mg of 60%mg/ml use 60ml of 100mg/ml and add 40ml of pg result will be 60mg/ml nic.
    If you want to mix it all at once use 120 ml of 100mg/ml and add 80 ml of PG.
  3. Like
    FXRich got a reaction from cany in Which would you choose...?   
    I have retired most of my Subtank minis, I mostly use Vapefly Brunhilde tanks now, they are a little smaller than the Subtank mini and hold more juice. No coil to replace and only take about 5 minutes to rebuild.
  4. Like
    FXRich got a reaction from kayakiit in COVID-19   
    Some studies have shown that propylene glycol kills viruses
    .https://www.vapes.com/blogs/news/research-shows-propylene-glycol-vapor-kills-airborne-influenza-virus
    Don't know if its true or not.
     
  5. Like
    FXRich got a reaction from VapeMama in Where is everyone   
    My bike has a brake pedal, and a shift pedal.
    The vape mail ban isn't working very well, I received a vapefly Siegfried kit last week, also received a vapefly Brunhilde the week before. I received 2 orders from China, and 1 from Europe.
  6. Like
    FXRich got a reaction from Tam in Where is everyone   
    My bike has a brake pedal, and a shift pedal.
    The vape mail ban isn't working very well, I received a vapefly Siegfried kit last week, also received a vapefly Brunhilde the week before. I received 2 orders from China, and 1 from Europe.
  7. Like
    FXRich got a reaction from cany in COVID-19 How's everything going in your area?   
    I don't have a mask. We drove past the hospital today, they have a tent set up for drive thru testing. The only people there were the ones doing the testing, they looked bored. I don't know why the low rate of infection in Central Oregon. Two counties next to us are Crook county (which is a 10 minute drive from where I live) with 1 infection and Harney county with 0 infections. I was looking at a map found here  https://usafacts.org/visualizations/coronavirus-covid-19-spread-map/  and noticed there are 7 counties in Colorado with 0 infections. From what I have figured out places with a low population density have fewer cases if any at all.
  8. Like
    FXRich got a reaction from cany in COVID-19 How's everything going in your area?   
    I haven't been to town in a week and a half, place  could be overrun with zombies for all I know. Out where I live people tend to stock up on stuff, normally we have 2 or 3 months worth of food in the freezer or on the shelf. We have no reason to go anywhere so are just staying home.
  9. Like
    FXRich got a reaction from Tam in COVID-19 How's everything going in your area?   
    I haven't been to town in a week and a half, place  could be overrun with zombies for all I know. Out where I live people tend to stock up on stuff, normally we have 2 or 3 months worth of food in the freezer or on the shelf. We have no reason to go anywhere so are just staying home.
  10. Like
    FXRich got a reaction from Tam in Before We All Panic.....   
    I find it strange that only the generation that sometimes eat tide pods are the ones that are suffering from lung disease. I have been vaping for a long time, and my doctor said my lungs have improved. I think the question should be what are they vaping?
    The news media never tell the whole story, only the parts that they want to.
  11. Like
    FXRich got a reaction from Walt in Cleaning Vape coils   
    The best I have found for cleaning coils, and tanks is a sonic cleaner.
  12. Like
    FXRich got a reaction from Walt in safe build mech mod with 21700 single battery   
    A .2 coil with a fully charged battery will pull about 21A, so you probably won't blow yourself up.
  13. Like
    FXRich got a reaction from thotz in safe build mech mod with 21700 single battery   
    your battery fully charged will put out 4.2V at 30A you can have a 0.14 coil. 3.7 is the nominal voltage the less the charge the lower the volts, the more it is charged the more the volts. You should build to the highest volts.
    http://www.steam-engine.org/ohm.html
  14. Like
    FXRich got a reaction from cany in Getting back too my roots   
    I use a couple of PT2s on subvod batteries as part of my daily rotation, good flavor and less vapor to cloud everything up. (1.8 coils)
  15. Like
    FXRich got a reaction from rickyharake in battery sizing   
    I don't build any coils below .5 ohms, most of my coils are .7 - .8, unless I use dual coils I never get below .5
    Smok coils are usually dual coil or even more, I believe they make a 8 coil setup. A .15 setup with 8 coils would be 1.2 ohms per coil, takes a lot of power to fire 8 coils.
    As far as the LG HG2 batteries go they are all I use, so I had to mention that they are 20A.
  16. Like
    FXRich got a reaction from ijustwannavape in Smok T-Priv 3 won't recognize new coil- only reads "Check Atomizer"   
    You don't say what kind of tank and mod you have. The most common solution to your problem is probably the center pin on the mod isn't high enough, if you use a pin or toothpick to pry it up a little bit it will probably help. If you use a metal pin or needle to pry it up keep your fingers away from the fire button, or remove the batteries if possible.
    I guess you did say what kind of mod you have in the title.
  17. Like
    FXRich got a reaction from rickyharake in battery sizing   
    I hate to disagree with a fellow poster, but mooch rates the LG HG2 as a 20A battery, here is a link 
    https://www.reddit.com/r/electronic_cigarette/comments/7p5pm9/bench_retest_results_lg_hg2_20a_3000mah_18650a/
  18. Like
    FXRich got a reaction from Bebop in Kanger Subtank Mini   
    I always use spaced wraps, I make the coil using tight wraps, then stick a needle between the wraps to get them spaced evenly after it is installed in the RBA, works for me.
  19. Like
    FXRich got a reaction from Tam in Emergency coil construction   
    I believe the .9 measurement was probably wrong. To get .9 ohms using 22g 304 you would need to do 30 wraps using a 3mm id even using a 5mm id you would need 20 wraps. (that is according to steam) If you checked the resistance using a multimeter you would have to subtract the resistance of the leads, which can vary depending on the quality, and the length of the leads.
    If nothing else use the wire out of a twisty tie, just strip the plastic off of it.(seen that in another post)
  20. Like
    FXRich got a reaction from Smoking Joe in Say Something Positive About E-Cigarettes? You Must Be A Bot Say Scientists   
    I'm a BOT (Biker Off Tobacco)
  21. Like
    FXRich got a reaction from Walt in Say Something Positive About E-Cigarettes? You Must Be A Bot Say Scientists   
    I'm a BOT (Biker Off Tobacco)
  22. Like
    FXRich got a reaction from Walt in What Are You Vaping Today?   
    Mad scientist concoctions are the best. I make a cherry cheesecake, pretty good stuff. A few weeks ago I got some new flavors that I haven't tried yet, I have been using TFA caramel, but read a lot of good things on the net about salted caramel by FW, also got some Madagascar vanilla, and some sweetener. Going to have to try them soon.
  23. Like
    FXRich got a reaction from Walt in What Are You Vaping Today?   
    I have been using French Vanilla in my mixes, I figure using the Madagascar vanilla would be much better.
  24. Like
    FXRich got a reaction from Tam in Vape pen issues   
    The ones I had did have air holes in the very bottom, but I guess different brands have different designs. I tried cleaning the ones I had with rubbing alcohol, and it did help for awhile, but went bad again. About the only thing you can do is get a different setup that uses a fire button instead of depending on air flow to fire it. Don't know about the one you have, but mine had a hole through the middle of the contact pin for the air to flow, that's how juice got into the electronics.
  25. Like
    FXRich got a reaction from Walt in Vape pen issues   
    The ones I had did have air holes in the very bottom, but I guess different brands have different designs. I tried cleaning the ones I had with rubbing alcohol, and it did help for awhile, but went bad again. About the only thing you can do is get a different setup that uses a fire button instead of depending on air flow to fire it. Don't know about the one you have, but mine had a hole through the middle of the contact pin for the air to flow, that's how juice got into the electronics.
×
×
  • Create New...

Important Information

Terms of Use Privacy Policy Guidelines